Email
USA 800.959.5050  Direct 801.298.5900|
The leader in customized protection solutions
ZERO offers three standard nut plate pattern configurations:
  • A box equipped with nut plates and attaching hardware
  • A cover equipped with nut plate screw and washer assemblies
  • Moisture resistant assemblies (nut plates spaced no more than 4" apart, center-to-center)
For your convenience, we have established a recommended nut plate pattern for every outside-fitting cover. However, if you need to build to custom specifications, you may refer to the Cover Specifications table located in the technical white papers to review size requirements for each nut plate pattern.

Please note that flush-fitting and inside-fitting covers may not be utilized as nut plate covers, and tight-fitting covers must be no higher than -5 or 0.31" for use with a nut plate.

When ordering any enclosure, add the required nut plate pattern as a special order. Be sure to specify the same nut plate pattern for both the enclosure and the cover.

Remember that ZERO can save you time and money by fulfilling all your modification needs in-house. Eliminate extra vendors and let ZERO finish the job for you.
Unit of Measure

Minimum Order

N/A 1

Deep Drawn Type

N/A Rectangle/Square

Made In

N/A USA

Heat Treating

N/A Standard heat treating is Fast and Slow Cycle Hydrogen Annealing. ZERO can Heat Treat Alloy 6061-0 to a T-4 or T-6 condition in conjunction with the drawing process.